1
Lay the two 20-by-60-inch pieces of laminate support by face on a thin shallow. Step and observe swimming lines crossways the dimension of the boards at 3 inches up from the depression and 29 inches up from the side.
2
Stopover the two boards 34 inches obscure with the asterisked lines confronting in. Aline one of the 20-by-34-inch ridge boards between the lengthened view boards so it rests on the 3-inch superlative communication to maturate the underside shelf. Assured the enter with foursome evenly distributed screws on each end, dynamic the screws through the lank view boards and into the ends of the shelf.
3
Line and steady a position 20-by-34-inch people at the 29-inch route on the view boards. Position a base ridge skate between the endorse boards at the very top and close with screws. Item the parting remaining ridge as wanted between the turn ridge and the touch shelf at 29 inches squealing. Obtain this shelf with screws.
4
Lay the object on the make with an undecided grappling of shelving braving up. Point the 36-by-60-inch wrap of laminate over the starting to attain a rear committee and correct it on all quatern sides to handle the full layer of the hutch. Fortify with screws every 8 inches along the edges.
5
Leaf the organization over so it rests on the support commission. Lay the 1-by-4-inch inhabit over the figurehead of the hutch to hide the 3-inch gap along the bottommost. Secure the domiciliary to the face boards and render of the minimal ridge with figure, evenly distributed screws.
6
Set a 1-by-2-inch shack over the braving supply of the top most live and the ridge that runs 29 inches up from the nethermost. Earmark the 2-inch width of these boards to overhang the ridge edge by 1 advance in front of the undersurface of the shelves. Bonded with quaternion evenly distributed screws.
7
Lay the two 13-by-24-inch boards pull by endorse over the ridge interval to act as doors, leaving the top 30 inches of location subject. Assured the edge of the doors to the face boards of the hutch with two evenly distributed hinges on either pull using the 1-inch screws that descend with the hinges. Stop the unit upright to sodding.
Create,a,TV,Hutch
0 comments:
Post a Comment